User Manual

Message Meaning
Only one DCA can be rolled out at one time.
You cannot roll-out DCA members on multiple bays
simultaneously.
Operating as the word clock master. This unit is the clock master.
Overlay turned off. Overlay has been turned off.
Overlay turned on. Overlay has been turned on.
Page bookmarked The page is bookmarked.
Power loss to PSU detected (CS X)
One of the two power supply units failed to supply power.
“X” represents the power supply unit (A or B) for which power
failure was detected.
PREVIEW Mode : Cannot Use This Function.
This function cannot be used in Preview mode, and was
ignored.
PREVIEW Mode : Disabled Preview mode was disabled.
Preview mode was disabled. Preview mode was enabled.
Same page is already open
The page cannot be displayed because the same page is
already open on another screen.
Saving aborted The file save operation was interrupted.
Scene #XX already exists
The scene renumbering operation cannot be completed
because a scene number that already exists was specified.
Scene #XX is empty! A scene you tried to recall does not exist.
Scene #XX is protected!
The scene is protected, and your operation (for example,
delete) cannot be completed.
Scene delete undone The scene delete operation was undone.
Scene duplicate undone The scene copy operation was undone.
Scene recall undone The scene recall operation was undone.
Scene store undone The scene store operation was undone.
Screen captured A screen has been captured.
Software control for this card is disabled. Check the card's
DIP SW setting.
This card is not working properly. Check the card’s DIP
switch setting.
Software exception detected! Restart this console as soon as
possible.
An abnormality occurred in software. Restart this control
surface immediately.
Software exception detected! Restart this editor as soon as
possible.
An abnormality occurred in software. Restart Editor
immediately.
Song file not found! The song file to play cannot be found.
Switch Active Engine from xx to yy? OK to switch the active engine from xx to yy?
Sync error! [XX]
The digital input signal at the [XX] connector is not syncing
with the master clock. Make sure that the input signal is
syncing with the master clock. Otherwise, noise may be
heard.
System Config can only be viewed and edited using the
Active DSP Engine.
System Config can be displayed and edited only for the
active engine.
Temporary channel link released A temporary channel link was released.
This device is currently online and cannot be changed.
This device is currently on-line. You cannot change the
device type.
This device is not found. This device is not found.
This feature is not available in editor software This feature is not available in Editor.
975
Messages > Messages