User Manual

CONTENTS

Part names & functions

22 RIVAGE PM StageMix User Guide

■ OSCILLATOR screen

You can set up the oscillator.

1 MODE buttons

Select one of the oscillator operating modes.

2 LEVEL slider

Sets the oscillator output level.

If the oscillator mode is set to SINE 2CH, two sliders (L/R) will be displayed.

3 FREQ slider

Sets the oscillator frequency.

This slider is displayed if the oscillator mode is set to SINE or SINE 2CH.

4 LPF/HPF sliders

These sliders are displayed if PINK NOISE or BURST NOISE is selected.

They adjust the cutoff frequency of the oscillator’s low and high pass filters.

5 LPF ON button/HPF ON button

Turns the LPF/HPF on or off.

6 Width slider

This slider is displayed if BURST NOISE is selected.

It adjusts the length of noise being output intermittently.

7 Interval slider

This slider is displayed if BURST NOISE is selected.

It adjusts a gap between noises.

8 OUTPUT button

Turns the oscillator on or off.

9 OUTPUT level meter

Displays the oscillator output level.

If the oscillator mode is set to SINE 2CH, two meters (L/R) will be displayed.

)