User Manual

CONTENTS
Setup
6 RIVAGE PM StageMix User Guide
Configuring StageMix
Launch StageMix.
The SELECT MIXER screen appears. This screen enables you to do the following:
• Engage Offline Demo mode, use the StageMix features, and navigate the user interface.
• Select the RIVAGE PM system on the network and start using StageMix.
Offline Demo mode
Press the OFFLINE button in the SELECT MIXER screen to engage Offline Demo mode to navigate the StageMix application while the
RIVAGE PM system is offline (that is, not connected to StageMix). Please note that the level meters and most scene memory features will be
disabled in this mode.
Selecting a console and starting the operation
Once the iPad is set up to link to the RIVAGE PM system, select the system from the list, and then press the CONNECT button.
If the maximum number per control surface/console (two instances) of StageMix installations have already been connected to the RIVAGE PM
system, a prohibiting icon will appear to the left of the IP Address. If you select a RIVAGE PM system that is displayed with a prohibiting icon
in StageMix, or if you select a system that features unsupported firmware, and then you press the CONNECT button, a message will appear
indicating that the connection was not made.
Once StageMix receives parameter data from the RIVAGE PM system, the StageMix setup process is complete.
If a connection between StageMix and the RIVAGE PM system cannot be established, refer to the Troubleshooting section at the end of this
User Guide.