User Manual

ManualsBrandsYamaha ManualsBrass & WoodwindsSILENT Brass Personal Studio

Yamaha Silent Brass

Personal Studio ST7

Contents of Set

● Personal Studio ST7 ● Owner’s Manual

Thank you for purchasing the Yamaha Silent

Brass Personal Studio ST7. In order to obtain

the maximum performance and enjoyment from

your ST7, we urge you to read this Owner’s

Manual thoroughly before using. Please keep

this Owner’s Manual, and the warranty in a safe

place for later reference.

* Pickup Mute are not included.

Summary of content (10 pages)

PAGE 1
Yamaha Silent Brass Personal Studio ST7 Thank you for purchasing the Yamaha Silent Brass Personal Studio ST7. In order to obtain the maximum performance and enjoyment from your ST7, we urge you to read this Owner’s Manual thoroughly before using. Please keep this Owner’s Manual, and the warranty in a safe place for later reference. Contents of Set ● Personal Studio ST7 * Pickup Mute are not included.
PAGE 2
Disconnecting the cable while the power is ON may result in damage to the unit. The sudden noise may also may result in hearing impairments. PLAYER Signal path REHEARSAL ROOM When playing in a standing position, the hook on the back of the ST7 is convenient for clipping the unit onto a belt.
PAGE 3
Your ST7 will give you years of reliable service if you follow the simple rules given below: ■ Location Do not expose it to the following conditions to avoid deformation, discoloration, or more serious damage. • Direct sunlight (e.g. near a window). • High temperatures (e.g. near a heat source, outside, or in a car during the daytime). • Excessive humidity. • Excessive dust. • Strong vibration. ■ Power Supply • Turn the power switch OFF when not in use.
PAGE 4
Battery Notice: This product may also use “household” type batteries. Some of these may be rechargeable. Make sure that the battery being charged is a rechargeable type and that the charger is intended for the battery being charged. When installing batteries, do not mix old batteries with new, or with batteries of a different type. Batteries MUST be installed correctly. Mismatches or incorrect installation may result in overheating and battery case rupture.
PAGE 5
Set up and Use Personal Studio ST7 ■ Top Panel ■ Front Panel REHEARSAL ROOM POWER OFF ON LINE OUT AUX IN q CONCERT HALL CHURCH DC10 -12V t !3 !2 REVERB MODE !1 o AUX IN AC Adaptor PA-1D !0 REVERB LEVEL i PLAYER 2 y u MASTER VOLUME PICKUP MUTE 1 2 PHONES 1 2 w r PLAYER 1 The above illustration shows the standard settings of each control.
PAGE 6
Claw Insert the batteries as shown below. Belt hook Attaching the battery cover is easier if you press down on the notched portion (4 lines) and the claw simultaneously.
PAGE 7
Power Supply The Personal Studio ST7 can be operated with battery or AC power. Always turn the power OFF when making AC power connections or replacing batteries. Using a Power Adaptor Please use the supplied power adaptor. *(adaptor not included in some countries) 1. Plug the DC output cable from the adaptor into the DC10-12V jack q on the top panel. (See the Illus. above) 2. Plug the AC adaptor into a convenient wall AC power socket. Using Batteries 1.
PAGE 8
Using the Silent Brass Before connecting the cable and attaching the mute, make sure the power is switched OFF and the earphones are removed from your ears. 1. Connect the ST7 PICKUP MUTE 1 Jack w to the Pickup Mute’s Output Jack with the supplied cable. A lock nut is attached to one end of the cable. Securely attach the lock nut end of the cable to the Pickup Mute’s Output Jack, then tighten the lock nut. * Don’t connect the end of the cable that is not equipped with the lock nut to the mute.
PAGE 9
About the Reverb The ST7’s internal processor includes 3 reverb types. Reverb is added to the input signal received by the PICKUP MUTE 1/2 w inputs. 1. Set the REVERB LEVEL Dial !0 to about the mid level point. 2. Pressing the REVERB MODE button !11 will cause the REVERB MODE to cycle through its 3 REVERB MODES. ● REHEARSAL ROOM Simulates the natural reverberation of a rehearsal room. ● CONCERT HALL Duplicates the longer reverberation time of a concert hall.
PAGE 10
Using the AUX IN/LINE OUT Jacks ■ The AUX IN jack The ST7’s AUX IN jack !2 can be used to connect an external stereo signal source to the ST7. Connecting a CD player, tape recorder, etc. to the AUX IN jack with an audio cable allows you to play along with an external audio source. POWER OFF ON DC10 -12V LINE OUT AUX IN !3 The AUX IN jack’s !2 signal level is controlled by the AUX IN VOLUME o control.