User Manual

47
English
Chapter
8 Appendix
Messages
Message Situation Remedy
The unit is being initialized to the factory default
settings.
DO NOT turn the unit off when “CLr” appears in the
display.
The song le is not compatible with the unit, or the
song le may be damaged.
You cannot select this song le.
The USB storage device is protected. Unprotect the USB storage device.
The capacity of the USB storage device becomes full. Delete unnecessary les on the USB storage device
(page 31), or use another USB storage device with
sufcient capacity.
The number of les and folders exceeds the system
limit.
Delete unnecessary les on the USB storage device
(page 31).
Audio song playback or recording has failed. If you are using a USB storage device to which data has
already been stored or deleted a number of times, rst
make sure that the device does not contain important
data, then format it and connect to the unit again.
A malfunction has occurred in the unit. Contact your nearest Yamaha dealer or authorized
distributor.
The capacity of the internal memory on the unit or the
USB storage device is running out.
Delete unnecessary les to ensure sufcient capacity
before staring recording (page 31).
The internal memory is being cleaned up. All settings
made and user song les on the internal memory are
being cleared, because the power has been turned off
before the operations were completed.
DO NOT turn the unit off when “FCL” appears in the
display.
The capacity of the internal memory on the unit or the
USB storage device is insufcient, and the operation
cannot be completed.
Delete unnecessary les to ensure sufcient capacity
before staring recording (page 31).
You tried to overwrite or delete a protected song. You cannot overwrite or delete a protected song.
You tried to overwrite a read-only le. Cancel the read-only setting for the le.
The USB storage device connected to the unit is
unformatted.
Format the USB storage device using a computer.
The overcurrent is induced in the USB storage devices. Disconnect the device from the USB port, and then turn
the unit on again.
The unit cannot communicate with the USB storage
device connected.
Disconnect the USB storage device and connection it
again. If the message still appears even when the USB
storage device is connected properly, the device may be
damaged.
This USB storage device connected to the unit is not
supported on the unit.
Try another USB storage device.
The number of the USB storage devices connected
exceeds the system limit.
You can use only one USB storage device with the unit.