User Manual

SLB300 Owner’s Manual

Changing Strings

Make sure you purchase Double Bass strings. The SILENT Bass

uses a string length of

1,040 mm (41”).

 Winding the Strings

1. Hook the string’s ball end into the string hole on the tailpiece. Make sure that the ball end is

securely positioned in the end of the string hole slit.

* If the ball end is larger than the string hole, thread the opposite end of the string through the

hole from the back side of the tailpiece.

2. Pull the string down toward the end pin and wrap the string around the end of the tailpiece mak-

ing sure it fits into its corresponding groove at the bottom of the tailpiece. Pull the string up and

over the bridge.

• Do not remove all strings at the same time. Make sure to change the strings one at a time.

NOTICE

• The ends of the strings are sharp and can cut fingers. Use caution when

changing strings.

• When changing or adjusting strings, do not put your face close to the instru-

ment. The string may suddenly break resulting in eye injury or other acci-

dents.

Tailpiece

String

Ball end