Owner's Manual

10
SPX2000 Editor Owner’s Manual
[HPF]
This filter cuts the low frequency range of the reverberation. The range below the frequency specified by this value
is cut. This filter does not affect the original source sound. Drag the icon to change the value.
[LPF]
This filter cuts the high frequency range of the reverberation. The range above the frequency specified by this
value is cut. This filter does not affect the original source sound. Drag the icon to change the value.
[Hi Ratio]
Length of reverberation in the high frequency range. The reverberation duration of the high frequency range is
expressed as a ratio relative to Reverb Time. Drag the icon to change the value.
[Lo Ratio]
Length of reverberation in the low frequency range. The reverberation duration of the low frequency range is
expressed as a ratio relative to Reverb Time. Drag the icon to change the value.
[Low Freq]
Frequency value that serves as the basis for the Lo Ratio value. The frequency band below this value is affected by
the Lo Ratio parameter setting. Drag the icon to change the value.
Filter Frequency Response Curve
The curve changes depending on the HPF and LPF values.
Reverberation images
These images represent the high-range (10kHz), mid-range (1kHz), and low-range (100Hz) reverberation. These
images change shape depending on the parameter values. The vertical axis represents the level; the horizontal axis
represents reverb time; the shape represents the envelope.
Reverb time curve
This curve represents the high-range (10kHz), mid-range (1kHz), and low-range (100Hz) reverb time. The curve
changes depending on the Reverb Time, Hi Ratio, and Lo Ratio parameter values.
[Auto Zoom] button
Click the button to automatically adjust the time axis (horizontal axis).
Time Axis Set button
Use this button to specify the time duration (in seconds) as displayed by the time axis (horizontal axis).
[] (Zoom Out) button
Click this button to increase the time value (in seconds) as displayed by the time axis (horizontal axis).
As a result, the display zooms out on the horizontal axis.
[] (Zoom In) button
Click this button to decrease the time value (in seconds) as displayed by the time axis (horizontal axis).
As a result, the display zooms in on the horizontal axis.
[INPUT]/[OUTPUT] Level meter
SPX2000 Editor displays the effect input level or output level. Use the [IN]/[OUT] buttons in the Effect Editor
window to switch between input and output level metering.
[MIX] slider
This slider enables you to adjust the mix balance of the dry and wet (effect) sounds. When the balance is 0%, only
the dry sound is output. When the balance is 100%, only the wet sound is output.
8
9
)
!
@
#
$
%
^
&
*
(
º
¡
Getting StartedAppendix
Using SPX2000
Editor Windows