User Manual

En
4
Battery use
• Do not use batteries other than specified batteries.
Doing so may cause fire or burns, or result in fluid leakage that may cause skin
inflammation.
• Do not put in a pocket or bag, carry, or store batteries together with pieces of metal.
The battery could short, burst, or leak, causing a fire or injury.
• Always make sure all batteries are inserted in conformity with the +/- polarity
markings.
Failure to do so might result in a fire, burns, or inflammation due to fluid leaks.
?????
• When the batteries run out, or if the unit is not to be used for a long time, remove
the batteries from the remote control to prevent possible leakage of the battery
fluid.
• When storing or discarding batteries, insulate the terminal area by applying tape, or
some other protection.
Mixing them with other batteries or metal objects can cause a fire, burns, or
inflammation due to fluid.
Notice
Indicates points that you must observe in order to prevent product failure, damage or
malfunction and data loss.
Power supply
• If not using the unit for a long period of time, be sure to pull the power plug from
the outlet. Even if this unit is turned off by [z](Standby/On), a minute current is still
flowing.
Installation
• Do not use this unit in a location that is exposed to direct sunlight that becomes
extremely hot, such as near a heater, or extremely cold, or that is subject to
excessive dust or vibration. Failure to observe this may cause the unit's panel to
become deformed, the internal components to malfunction, or for operation to
become unstable.
• If using a wireless function, avoid installing this unit near metal walls or desks,
microwave ovens, or other wireless network devices.
Obstructions could shorten the transmission distance.
Connections
• If connecting external units, be sure to thoroughly read the manual for each unit
and connect them in accordance with the instructions.
Failure to properly handle a unit in accordance with the instructions could cause
malfunctions.
• Do not connect this unit to industrial units.
This unit has been designed to connect to a consumer-use unit. Connection to an
industrial unit could cause this unit to malfunction.
Handling
• Do not place vinyl, plastic, or rubber products on this unit. Failure to observe this
may cause discoloration or deformation in the panel of this unit.
• If the ambient temperature changes drastically (such as during unit transportation
or under rapid heating or cooling) and there is a chance condensation may have
formed in the unit, leave the unit for several hours without turning on the power
until it is completely dry before use. Using the unit while there is condensation can
cause malfunctions.