User Manual
Table Of Contents
- PRECAUTIONS
- NOTICE
- Information
- Table of Contents
- Introduction
- Controls and Functions
- Quick Start Guide
- Using this Product along with a DXL1K Powered Speaker
- Playing Bluetooth® Audio
- Controlling the Unit from STAGEPAS Controller
- Initializing the STAGEPAS 1K mkII
- Storing the Unit
- Troubleshooting
- General Specifications
- Block Diagram
Quick Start Guide
STAGEPAS 1K mkII Owner’s Manual 11
Quick Start Guide
Attaching the line array speaker and
spacers
Use the included spacers to install the line array speaker
at approximately the same height as the ears of the
audience. The line array speaker features a grille.
1. Insert the line array speaker and
spacers firmly into the sockets
one by one.
Use the spacers as needed.
NOTE
Insert the line array speaker and spacers
firmly into the sockets. If the connectors are
not in contact sufficiently, no sound may be
output.
Connecting microphones, musical
instruments, or audio devices to the
mixer section
Before making connections, lower the volume level to the
minimum by rotating the [LEVEL] controls counter-
clockwise.
Connection example
2. Connect desired devices, such as a
microphone, or a musical instrument to the
input jacks of the mixer section.
Getting sound out of the speaker
Make sure that the power to the STAGEPAS 1K mkII is
turned off.
3. Connect the plug on the included power
cord to the [AC IN] jack on the rear panel of
the unit.
Spacers x 2 Spacer x 1 No spacers
RL
RL
Electronic keyboard
Acoustic-electric
guitar
Microphone