User Manual

Playing Bluetooth® Audio
14 STAGEPAS 1K mkII Owner’s Manual
Playing Bluetooth
®
Audio
You can set up the STAGEPAS 1K mkII so it will play audio
files stored in Bluetooth devices, such as a mobile device.
Registering (pairing) a Bluetooth
®
device
Before you can connect a Bluetooth device for the first
time, you need to “pair” the device. “Pairing” refers to
registering one Bluetooth device with another Bluetooth
device.
Once pairing is complete, you will be able to reconnect
those devices easily after you terminate a Bluetooth
connection.
1. Make sure that the (Bluetooth) LED is
turned off. If the LED is lit steadily or is
flashing, press the (Bluetooth) switch to
place the Bluetooth function in standby
mode.
2. Press and hold down the (Bluetooth)
switch for three seconds or longer.
The (Bluetooth) LED will flash
rapidly, indicating that the unit is
ready for pairing.
3. Turn on the Bluetooth function on the
Bluetooth device that you want to pair.
For more information, refer to the owner’s manual for
the Bluetooth device.
4. Once the Bluetooth device displays a list of
other Bluetooth devices that are available for
connection, select STAGEPAS 1K mkII
AUDIO.
NOTE
You can change the name of the unit in the Device Name
setting of STAGEPAS Controller.
When the pairing process is
complete, the Bluetooth
connection will be established
and the (Bluetooth) LED will
light up.
NOTE
• The STAGEPAS 1K mkII enables you to pair (register) up to
eight Bluetooth devices. Once the ninth Bluetooth device has
been paired successfully, the pairing information for the
Bluetooth device that was connected earliest will be deleted.
• You must complete the pairing process on the Bluetooth
device within two minutes.
Connecting a Bluetooth
®
device
 Using the STAGEPAS 1K mkII for pairing
1. Press and hold down the (Bluetooth)
switch for one second.
The (Bluetooth) LED will flash slowly, indicating
that the unit is searching for a registered Bluetooth
device.
2. Turn on the Bluetooth function on the
Bluetooth device that you want to connect.
When the connection is made automatically, the
(Bluetooth) LED will light up.
 Using the Bluetooth device for pairing
Even if the unit is in Bluetooth standby mode, you can still
connect your Bluetooth device by following the procedure
below on the device.
1. Turn on the Bluetooth function on the
Bluetooth device that you want to connect.
2. Select STAGEPAS 1K mkII AUDIO from the
list of Bluetooth devices displayed on your
Bluetooth device.
Playing audio files stored in a
Bluetooth
®
device
You can use the STAGEPAS 1K mkII to listen to an audio
file playing on your Bluetooth device.
Signals from the Bluetooth device are input to the ST
channel.
We recommend that you set the volume on the Bluetooth
device a little higher than normal, and then adjust the
volume for each channel using the ST [LEVEL] control.
Disconnecting the Bluetooth
®
device
To disconnect the Bluetooth device, do one of the
following:
• Use the Bluetooth device to disconnect.
(The (Bluetooth) LED will turn off.)
• Press the (Bluetooth) switch on the unit to engage
Bluetooth standby mode.
(The (Bluetooth) LED will turn off.)
Notice
Before you turn off the power to the unit, make sure that the
Bluetooth function is turned off. (Make sure that the
(Bluetooth) LED is turned off.) If you turn off the power to the
unit while the Bluetooth function remains enabled, the unit might
lose the pairing information.
If you receive a call or text message while playing audio
files on your Bluetooth device such as a smartphone,
audio file playback might be paused momentarily.
To avoid this interruption, enable Airplane Mode, and
then set Bluetooth to ON on your Bluetooth device.