User Manual

4 STAGEPAS 1K mkII Owner’s Manual
Inadequate ventilation can result in overheating, possibly
causing damage to the product(s), or even fire. Make sure that
there is adequate space around the product: at least 30 cm
above, 30 cm at the sides and 30 cm behind.
• Do not carry or transport the device unless it is disassembled.
Otherwise, you might be injured if the speaker or spacers
strike your head or body.
• Do not place the product in a location where it may come into
contact with corrosive gases or salt air. Doing so may result in
malfunction.
• Before moving the product, remove all connected cables.
• When transporting or moving the product, always use two or
more people. Attempting to lift the product by yourself may
result in injuries, such as back injuries, or cause the product to
be dropped and broken, which could lead to other injuries.
• Do not press the rear panel of the product against the wall.
Doing so may cause the plug and speaker cable to come in
contact with the wall and detach from the power cord,
resulting in short circuiting, malfunction, or even fire.
Maintenance
• Remove the power plug from the AC outlet when cleaning the
product.
Handling caution
• Do not insert your fingers or hands in any gaps or openings on
the product (vents).
• Do not rest your weight on the product or place heavy objects
on it.
• Do not operate the product if the sound is distorting.
Prolonged use in this condition could cause overheating and
result in fire.
• Do not use the included line array speaker with other
products, such as STAGEPAS 1K. Otherwise, malfunction,
overheating or fire might be caused.
• Confirm that the finished installation is safe and secure. Also,
carry out safety inspections periodically. Failure to observe
this may cause devices to fall and result in injury.
• Assemble and install in the manner instructed in the manual.
Falling or toppling may result in injury or damage.
The Bluetooth
®
word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
Yamaha Corporation is under license.
NOTICE
To avoid the possibility of malfunction/ damage to the
product, damage to data, or damage to other property,
follow the notices below.
Handling and maintenance
• Do not use the product in the vicinity of a TV, radio, or other
electric products. Otherwise, the product, TV, or radio may
generate noise.
• Do not expose the product to excessive dust or vibration, or
extreme cold or heat, in order to prevent the possibility of
panel disfiguration, unstable operation, or damage to the
internal components.
• Do not install in locations where temperature changes are
severe. Otherwise, condensation may form on the inside or
the surface of the product, causing it to break.
• If there is reason to believe that condensation might have
occurred, leave the product for several hours without turning
on the power until the condensation has completely dried out,
in order to prevent possible damage.
• Do not place vinyl, plastic or rubber objects on the product,
since this might cause alteration or discoloration of the panel.
• Do not use sodium hypochlorite solution, ethanol, benzine,
thinner, detergent or a chemical rag to clean the surface of the
product. Otherwise, the surface may become discolored or
deteriorate.
Information
About functions/data bundled with the product
• XLR-type connectors are wired as follows (IEC60268 standard):
pin 1: ground, pin 2: hot (+), and pin 3: cold (−).
About this manual
• The illustrations as shown in this manual are for instructional
purposes only.
• IOS is a trademark or registered trademark of Cisco in the U.S.
and other countries and is used under license.
• The company names and product names in this manual are
the trademarks or registered trademarks of their respective
companies.
About disposal
• This product contains recyclable components.
When disposing of this product, please contact the
appropriate local authorities.
* This applies only to products distributed
by YAMAHA CORPORATION OF AMERICA.
IMPORTANT
Please record the serial number of this unit in the space below.
Model
Serial No.
The serial number is located on the bottom or rear of the unit.
Retain this Owner’s Manual in a safe place for future reference.
(Ser.No)
Yamaha cannot be held responsible for damage caused by
improper use or modifications to the product, or data that is
lost or destroyed.
PA_en_12 2/2