User Manual

STAGEPAS 200BTR STAGEPAS 200 Owner’s Manual
13
Installing and Removing the Battery
Installing one BTR-STP200 rechargeable lithium ion battery pack enables you to use this product (STAGEPAS 200 or
STAGEPAS 200BTR) without connecting a power cord.
NOTICE
• To avoid over-discharge, this battery, as shipped from the factory, will not function when you first install it in the intended product. To
enable the battery function for first time use, you must install it in the product and then connect the product to an AC outlet using the
dedicated power cord.
• If you remove the battery from the unit, and then quickly re-install the same battery, a malfunction may occur. After removing the
battery, be sure to wait at least six seconds before re-installing the same battery in the unit.
Installing the battery
1 Disconnect the power cord from the AC
outlet or from the unit.
NOTICE
Installing or removing the battery while the power cord is
connected to the unit might cause the battery to
malfunction.
2 Place the unit upside down with the top
panel facing down, and then remove the
rubber feet.
3 Use a Phillips screwdriver to loosen the
four screws, and then remove the battery
compartment cover from the unit.
Tool required for installation: Phillips screwdriver
4 Loosen and remove the two screws that
will be used to affix the battery later in this
procedure.
5 Insert the battery into the battery
compartment so that the connector on the
battery will align with the connector slot
in the compartment, and then affix the
battery securely using the two screws.
NOTE
Tightening torque for the screws should be 1.2 Nm.
6 Replace the battery compartment cover
and affix it securely with the four screws.
NOTE
Tightening torque for the screws should be 1.2 Nm.
Rubber feet
Battery compartment
cover
Battery