User Manual

STAGEPAS 200BTR STAGEPAS 200 Owner’s Manual
23
Troubleshooting
If a problem persists, please contact your Yamaha dealer.
Symptoms Possible causes Action to take
Power does not turn
on.
You did not firmly and securely connect the power cord. Connect the power cord firmly and securely.
If the unit is running on the battery, the battery charge
level is not sufficient.
Plug in this product to an AC outlet with the power cord
to charge the battery.
Power shuts down
suddenly.
The vents on the unit are blocked. Since inadequate
ventilation can result in overheating inside this product,
the power may be turned off automatically to protect
the system from overheating.
Arrange the ventilation for better cooling, then turn the
power on again.
The unit will engage standby mode if the Auto Standby
function is enabled and no audio has been input for at
least 30 minutes.
Press the [P] (Standby/On) switch.
No sound is heard. If the [P] (Standby/On) indicator is flashing rapidly, it
indicates that the internal power amplifier is overloaded,
and the amplifier is muted to protect its circuits.
Leave the unit in a cool place for a while. The amplifier
will automatically reset itself.
Sound is distorted.
Noise is produced.
The [LEVEL] controls of any relevant channels and/or the
MAIN [LEVEL] control are set too high.
Turn the relevant [LEVEL] control to the minimum (zero),
then set the switch to the LINE/ LINK or LINE position,
and then slowly raise the [LEVEL] control.
The [MIC, LINE/LINK] switch or [MIC, LINE] switch is set to
the MIC position. If the input level from the source is
high, setting the relevant switch to the MIC position may
result in a distorted sound.
Set the switch to the LINE/LINK or LINE position.
The volume level of the external device connected to
the mixer is too high.
Lower the volume level of the external device.
Sound is not loud
enough.
The [LEVEL] controls of any relevant channels and/or the
MAIN [LEVEL] control are set too low.
Turn the relevant [LEVEL] control to the minimum (zero),
then set the switch to the MIC position, and then slowly
raise the [LEVEL] control.
The [MIC, LINE/LINK] switch or [MIC, LINE] switch is set to
the LINE position.
Set the switch to the MIC position.
The volume level of the external device connected to
the mixer is too low.
Raise the volume level of the external device.
Some settings can be controlled only from STAGEPAS
Controller.
Use STAGEPAS Controller to adjust the settings, or
initialize the unit.
The high-range
sounds and low-
range sounds are
unbalanced.
You turned the [EQ/PRESET] control clockwise or
counter-clockwise too much.
Set the [EQ/PRESET] control to the center (FLAT)
position.
Cannot connect
Bluetooth.
If the
[ ] (Bluetooth) indicator is lit, it means that the
unit is connected to a different Bluetooth device.
Cut the current Bluetooth connection, and then connect
to the desired Bluetooth device.
Pairing failed. In particular, the initialization process will
wipe off the pairing information.
Pair the device again.
Bluetooth audio
sound cuts
intermittently.
The unit may be located in the vicinity of a device that
emits electro-magnetic waves at a frequency of 2.4 GHz
(such as a wireless microphone transmitter, wireless LAN
device, microwave oven, etc.).
Locate the unit away from any device that emits electro-
magnetic waves.
The wireless LAN function on the Bluetooth device is
enabled.
Turn off the wireless LAN function, and enable only the
Bluetooth function.
The [ ] (Charge)
indicator is flashing
rapidly.
Battery has abnormality. Stop using the unit immediately, remove the battery
from the unit, and then contact your Yamaha dealer.