User Manual

English
Quick Start Guide
STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual
13
7. Set the MIC/LINE switch to the MIC (N) position to connect a microphone, and
to the LINE (O) position to connect a musical instrument or audio device.
8. Turn on the power of the connected sound source (if applicable), then the
mixer.
The POWER LED lights.
9. Set the MASTER LEVEL control to the “D” position.
10. While playing your instrument or singing into the microphone, use the LEVEL
control to adjust the volume of the corresponding channel.
11. Use the MASTER LEVEL control to adjust the overall volume.
If you hear the sound and the volume seems appropriate, setup is complete. If not,
please refer to the checklist in the “Troubleshooting” section.
NOTE
To avoid loud, unexpected noise from the speaker, first turn off the power to the mixer, then
the connected sound source (such as a musical instrument or audio device).
I When the volume is too loud
Turn the LEVEL control to the minimum (zero). Set the MIC/LINE
switch to the LINE (O) position, then slowly raise the LEVEL control
until the desired volume is reached.
I When the volume is too soft
Turn the LEVEL control to the minimum (zero). Set the MIC/LINE
switch to the MIC (N) position, then slowly raise the LEVEL control
until the desired volume is reached.
Adjusting the volume