User Manual

Initializing the STAGEPAS 1K mkII
16 STAGEPAS 1K mkII Owner’s Manual
Initializing the
STAGEPAS 1K mkII
If you want to reset the parameters that were programmed
from STAGEPAS Controller, or reset the Bluetooth pairing
(registering) information to the factory default settings,
follow the steps below:
1. Turn the power switch off.
2. While pressing and holding down the
[DUCKER] switch and [REVERB] switch
simultaneously, turn on the I/O (Power)
switch on the rear panel.
While the unit is being initialized, the [POWER] LED,
[DUCKER] LED, and (Bluetooth) LED will flash.
3. When the initialization is complete, the unit
automatically restarts.
After the initialization process, the parameter values
will change as follows:
* Parameters that can be controlled only from STAGEPAS
Controller
Storing the Unit
1. Install the included, dedicated cover over the
STAGEPAS 1K mkII.
2. Put the line array speaker and spacers into
the pocket that is marked with the Yamaha
logo.
To move the unit, open the flap on top of the
cover and hold the handle on the unit.
NOTE
For information regarding the DL-SP1K, an optional dolly
designed for use with the unit, please refer to the DL-SP1K
Owner’s Manual.
Parameter Value
REVERB
Knob position
EQ
REVERB TYPE/TIME
MODE
MONITOR LEVEL
MAIN LEVEL
REVERB ON/OFF Default (OFF)
MONO/ST MODE Default (MONO)
BLUETOOTH CONTROL
MODE
Default (OFF)
Bluetooth audio pairing
(registration) information
All cleared
DUCKER ON Default (OFF)
DUCKER* Default
CHANNEL LEVEL* Default (0 dB)
PAN* Default (CENTER)
REVERB LEVEL* Default (89(–3 dB))
BT NOISE GATE* Default (normal)
DEVICE NAME* Default (STAGEPAS 1K mkII)
SCENE*
Values for PRESET #1–8 are
cleared.
PASSCODE* Disabled