User Manual

② EQ knob
Specifies the EQ value.
From the center (FLAT) position, turn this knob counter-clockwise to cut the low range. Turn the knob clockwise
to boost both low and high ranges.
For this parameter, the white line indicates the value of STAGEPAS Editor, and the position of the knob on the
panel of the STAGEPAS 1K is shown as a dim color.
Default value: FLAT
③ PAN bar
Indicates and sets the pan value. This parameter can be set only by using STAGEPAS Editor.
Drag left or right to set the pan. Double-tap to return to the C (center).
The numeric value of the pan setting is shown below the knob.
Range: L32–C–R32
Default value: C
5.2. MASTER section
① REVERB button
Tap to turn reverb on/off. This is lit when on.
Default value: OFF
NOTE
• REVERB can also be turned ON/OFF using a foot pedal (FC5).
② MODE knob
Specifies the mode.
For this parameter, the white line indicates the value of STAGEPAS Editor, and the position of the knob on the
panel of the STAGEPAS 1K is shown as a dim color.
③ REVERB LEVEL knob
Indicates and sets the reverb level. This parameter can be set only by using STAGEPAS Editor.
The numeric value is shown below the knob.
Range: 0–100
Default value: 89
5. EFFECT/EQ/PAN screen
5.2. MASTER section | 9