User Manual

STAGEPAS 200BTR STAGEPAS 200 Owner’s Manual
22
Initializing the Settings for This Product
If you want to revert the settings for this product to the factory default settings, such as resetting the parameters that
were programmed from STAGEPAS Controller, or resetting the Bluetooth pairing (registering) information, follow the
steps below:
1 Turn the [P] (Standby/On) switch off.
2 While pressing and holding down the
[ ] (Bluetooth) switch and the MAIN
[FEEDBACK SUPPRESSOR] switch
simultaneously, turn the [P] (Standby/On)
switch on.
During the initialization process, the [P] (Standby/On)
indicator, MAIN [FEEDBACK SUPPRESSOR] indicator, and
[ ] (Bluetooth) indicator will flash.
Make sure that they are flashing, and then release your
fingers from the switches.
3 When the initialization is complete, the
unit automatically restarts.
*1 Parameters that can be controlled only from STAGEPAS Controller
Storing the Unit
If you plan not to use the STAGEPAS 200BTR or STAGEPAS 200 for a long period of time, remove the battery from the
unit and store the unit and battery separately.
While holding these down...
turn the
switch on.
EFFECT Knob position
EQ/PRESET Knob position
MODE Knob position
MAIN LEVEL Knob position
FEEDBACK SUPPRESSOR ON Default (OFF)
Bluetooth audio pairing
(registration) information
All cleared
CHANNEL LEVEL
*1
Default (0 dB)
LR-MONO SELECT
*1
Default (LR-MONO)
MAIN EQ
*1
Default (FLAT)
MONITOR/LINK MODE Default (MONITOR MODE)
EFFECT ON
*1
Default (ON)
REVERB LEVEL
*1
Default (−3 dB)
CHORUS LEVEL
*1
Default (−3 dB)
DELAY LEVEL
*1
Default (−3 dB)
REVERB TYPE/TIME Knob position
CHORUS
*1
Default
DELAY
*1
Default
DUCKER
*1
Default
DEVICE NAME
*1
Default (STAGEPAS200)
SCENE
*1
Values for SCENE #1–8 are
cleared.
PASSWORD
*1
Disabled
AUTO STANDBY
*1
Enabled
LAST MEMORY RESUME
*1
Default (OFF)