Sampling Unit Owner's Manual

Chapter 10 Jobs 233
CHAPTER 10
TRACK SET | FILTER TYPE
Use to: Select the filter type for each track.
●
This operation has no affect on the track’s current cutoff-frequency and resonance
settings. To change the cutoff frequency and resonance, use the corresponding
knob functions (→ p.210).
●
This operation does not apply to AUDIO IN and MASTER tracks. You cannot select
these tracks when working on this job.
●
You can select from the following four filter types. The default type is LPF.
LPF Low-pass filter [12dB/oct]. (Suppresses frequencies above the cutoff
frequency.)
BPF BBand-pass filter [12dB/oct]. (Suppresses frequencies outside the band
centered at the cutoff frequency.)
HPF High-pass filter [12dB/oct]. (Suppresses frequencies below the cutoff
frequency.)
BEF Band-eliminate filter [12dB/oct]. (Suppresses frequencies inside the
band centered at the cutoff frequency.)
Level
These frequencies are
cut.
Cutoff frequency
Level
These
frequencies
are cut.
Cutoff frequency
Level
These
frequencies
are cut.
Cutoff frequency
These frequencies pass
These
frequencies
are cut.
Level
Cutoff frequency
These
frequencies
pass.
These
frequencies
pass.
These
frequencies
pass.
These
frequencies
pass.
These frequencies are cut.