User Manual

10
● Winding the Strings
1 Before you string the instrument, set the adjuster so that
it is in the middle of its adjustment range. (All adjusters)
2 Place the ball (on the end of the string) in the notch on
the adjuster. Make sure the ball is properly inserted in the
adjuster’s notch.
3 At a point about 2 cm from the string’s end, bend the string at a right angle and insert the end into
the hole in the tuner. While pulling the string toward the bridge to maintain string tension, turn
the tuner machine to wind the string around the tuning post. Make sure the string is wound toward
the base of the post as shown in the illustration below.
The adjuster should be
set to the middle of its
adjustment range.
1st string (A)
4th string (C)
2nd string (D)
3rd string (G)
Adjuster’s notch
String
Ball
Insert the string’s
end into this hole
Wind the string
[Looking from the front]
String
About 2 cm
WH39310_SVC210_Body_R4.indb 10 15/01/20 18:27