Owner`s manual

KENTON PLUGSTATION USERS MANUAL

QUICK GUIDE TO PLUGSTATION COMMANDS:

STATUS LEVEL

P-XX – (XX is a number between 1-64) : This indicates a Performance value for the Plugstation

Performance memory selector

EXT – Indicates that Plugstation is running from an external wordclock

INT – Indicates that Plugstation is running from an internal wordclock

CARD EDIT LEVEL

BNTH– Bank select MSB. Allows you to select a Bank MSB message for a specific PLG card

BNTL– Bank Select LSB. Allows you to select a Bank LSB message for a specific PLG card

PROG – Program change message. Allows a specific program for each PLg card to be recalled

SVOL – Controls the amount of PLG board level is being fed back to the SW1000XG

SBAL – Controls the balance of the PLG card signal being fed back to the SW1000XG

YVOL – Controls the amount of signal being sent to the Y-BOARD outputs from each PLG card

YBAL – Controls the balance of the PLG card signal being sent to the Y-BOARD outputs for each

PLG card

YOPS – Selects which output the PLG card signal is being fed to on the Y-BOARD

PART – Selects the Part number that a specific PLG card part can be set to

CHAN – Selects the MIDI channel that a specific PLG card responds on