User Manual
[Example]
Reset slave management.
SWP1#l2ms reset
4.8.8 Show L2MS information
[Syntax]
show l2ms [detail]
[Keyword]
detail : Also show detailed information
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the following information according to the L2MS operating state.
•
If operating as a controller
•
Number of slaves being managed
• Information for the slaves being managed
• MAC address
• Model name
• Device name
• Route
• Uplink port
• Settings applied
• If operating as a controller, and "detail" is specified
• Number of slaves being managed
• Information for the slaves being managed
• MAC address
• Model name
• Device name
• Route
• Linked-up ports
• Uplink port
• Downlink port
• Settings applied
• Number of terminals connected
• Information for the terminals connected to the slave
• MAC address
• Ports of connected slaves
• Time at which terminal was discovered
• If operating as a slave
• Whether managed by the controller
• MAC address of controller (if managed)
[Note]
Information is not shown if L2MS is not operating.
The "detail" keyword is valid only if operating as a controller.
[Example]
If operating as a slave, L2MS information is shown.
SWP1>show l2ms
Role : Slave
Status : Managed by Controller (00a0.de00.0000)
4.8.9 Set the device information acquisition time interval for downstream of a wireless AP
[Syntax]
wireless-device-watch interval time
Command Reference | Maintenance and operation functions | 49