User Manual

For each item, shows the current value, upper threshold value, and lower threshold value for each SFP port.
Item Description
Temperature Internal temperature of the module (°C)
Voltage Voltage value (V)
Current Current value (mA)
TX-Power Strength of light produced (dBm)
RX-Power Strength of light received (dBm)
[Example]
Show the status of the SFP module.
SWP1#show ddm status
Temperature High Alarm High Warning Low Warning Low Alarm
Interface (Celsius) Threshold Threshold Threshold Threshold
------------ ------------ ------------ ------------ ------------ ------------
ge9 31.1 100.0 85.0 -40.0 -55.0
ge10 - - - - -
Voltage High Alarm High Warning Low Warning Low Alarm
Interface (V) Threshold Threshold Threshold Threshold
------------ ------------ ------------ ------------ ------------ ------------
ge9 3.34 3.62 3.46 3.13 2.97
ge10 - - - - -
Current High Alarm High Warning Low Warning Low Alarm
Interface (mA) Threshold Threshold Threshold Threshold
------------ ------------ ------------ ------------ ------------ ------------
ge9 3.8 16.0 15.0 2.0 2.0
ge10 - - - - -
TX-Power High Alarm High Warning Low Warning Low Alarm
Interface (dBm) Threshold Threshold Threshold Threshold
------------ ------------ ------------ ------------ ------------ ------------
ge9 -5.5160 0.4139 0.0000 -10.7058 -12.2184
ge10 - - - - -
RX-Power High Alarm High Warning Low Warning Low Alarm
Interface (dBm) Threshold Threshold Threshold Threshold
------------ ------------ ------------ ------------ ------------ ------------
ge9 -5.9226 2.5527 0.0000 -16.9897 -40.0000
ge10 - - - - -
10.2 Link aggregation
10.2.1 Set static logical interface
[Syntax]
static-channel-group link-id
no static-channel-group
[Parameter]
link-id : <1-12>
static logical interface number
[Input mode]
interface mode
[Description]
Associates the applicable interface with the static logical interface specified by link-id.
If this command is executed with the "no" syntax, the applicable interface is dissociated from the static logical interface.
[Note]
This command can be specified only for LAN/SFP port.
96 | Command Reference |
LAN/SFP port control