User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Map screen
Yamaha LAN Monitor for Win User Guide
24
1 Device Details
This area shows the following information. Depending on the device, some items will not be shown.
2 Port status
This area shows a graphic representation of information concerning the Yamaha switch and Dante-enabled
devices. Use the tabs located below the graphic to switch the information that is shown.
• [Port Status] tab: Shows the connection status and communication speed of each port.
• [Bandwidth(%)] tab: Shows the bandwidth usage of each port. (For switches only)
• [PoE status (Class)] tab: This area shows the power supply status for each port. (For PoE-enabled switches
only)
NOTE
For more details on the graphic display, refer to “Port icons in the “Device Details” view” (page 54).
The bandwidth usage update interval can be changed in the “Basic Settings” dialog box (page 13), under “Information
update interval for selected slave” - “Bandwidth”.
3 Information for the Dante-enabled device
This area shows information for the Dante-enabled device. To display information for the Dante-enabled device,
Dante Discovery/Dante Control and Monitoring must be installed (page 6).
“Label”
Shows the device label that was entered in the “Device Settings” dialog box or the
“Connected Devices” view.
“Model name”
Shows the model name of the device.
“Comment”
Shows the comment that was entered in the “Connected Devices” view. You can freely enter
information about the on-site cabling or the role of the device.
“Manufacturer”
Shows the manufacturer name of the device.
“IP address”
Shows the IP address of the device. The IP address of the device can be changed in the
“Device Settings” dialog box. This field is left blank for devices without an IP address.
“MAC address”
Shows the MAC address of the device.
“Serial”
Shows the serial number of the device.
“Firmware”
Shows the firmware revision of the device.
“Snapshot function”
Shows whether the device is monitored by the Snapshot function (On) or not monitored (Off).
“EEE”
Shows whether the power-saving function is enabled or disabled. This shows either Economy
Mode or Normal Mode for SWX2200 series devices.
“Fan Status”
For a switch with a built-in fan, shows whether the fan is operating normally or
malfunctioning.
“Fan RPM”
Shows the fan RPM for a switch with a built-in fan.
“Internal
temperature”
Shows the internal temperature of the switch.
“Sum of power might
be supplied”
Shows the sum of the maximum power capacity supplied to the switch-connected device.
Note that the power supply may be interrupted, depending on the condition, if this value
exceeds the limitation of the maximum power supply capacity for the PoE switch.
“Power being
supplied”
Shows the total power supplied from each port on the switch and from the entire device.
“Link aggregation”
Shows the link aggregation type.
Name
Shows the label of the Dante-enabled device.
“Transmit Flows”
Shows the transmit flow status.
“Receive Flows”
Shows the receive flow status.