User Manual
Table Of Contents
- Yamaha LAN Monitor for Mac
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Mac
NOTE
For more details on the graphic display, refer to “Port icons in the “Device
Details” view”.
The bandwidth usage update interval can be changed in the “Basic Settings”
dialog box, under “Information update interval for selected agent” -
“Bandwidth”.
❸ Information for the Dante-enabled device
This area shows information for the Dante-enabled device. To display information for the
Dante-enabled device, Dante Control and Monitoring must be installed.
Name Shows the label of the Dante-enabled device.
“Transmit Flows” Shows the transmit flow status.
“Receive Flows” Shows the receive flow status.
“Locked” / “Unlocked”
indicator
Indicates whether the audio signal is locked or unlocked.
Sampling frequency / bit-
length / latency
Shows the sampling frequency, bit-length, and latency of the
audio signal. The latency is shown in μ second units.
“Pull-up/down” Shows the sampling rate pull-up/pull-down setting.
“Mute” indicator Lit in red when the Dante-enabled device is muted.
“Tx” / “Rx”
Shows information about Dante transmission and reception.
[Utilization] : Shows the current amount of transmission and
reception in kbps units.
[Errors] : Shows the number of errors that occurred during
transmission and reception. The [Clear] button located at the
right resets the indication of the [Errors] field to 0.
“Primary” / “Secondary” Shows the status of the Dante “Primary” port and “Secondary”
port.
The link speed is shown inside the graphic of the port.
The setting of the Dante “Secondary” port is shown below the
graphic of the ports.
NOTE
For more about transmit flow and receive flow, and unicast and multicast, visit the
following Yamaha Pro Audio site, navigate to [Training & Support] → [Self-Training]
→ [Dante Network Design Guide], and refer to [Multicast Settings].
https://asia-latinamerica-mea.yamaha.com/en/products/proaudio/
❹ [Dante Controller] button
You can click this to start Dante Controller and configure Dante settings, such as patching. If
Dante Controller is not installed, an error message appears.
For details on using Dante Controller, refer to the Dante Controller User Guide.
9. Map screen
Yamaha LAN Monitor for Mac User Guide | 33