User Manual

“VLAN ID”
Shows the VLAN ID joined by the port to which the device is connected.
When multiple VLAN IDs are set, each VLAN ID will be separated with a
comma. Maximum of 9 (trunk=8, access=1).
The access port (A), and trunk port (T) will appear after the VLAN ID.
However, (A) will not appear when only the access port is in use.
“Snapshot” Specifies whether each device is included as a target of the snapshot
function.
Users can switch settings only for the devices other than agents.
Agents cannot be changed.
“Device Type” Shows an icon that indicates the type of device. You can use the pull-
down menu to switch the icon that is displayed.
[Device Label] You can enter a character string to identify the individual device.
[Model name] Shows the model name of the device. Some devices allow you to input
and edit the device name.
[Comment] Allows you to freely assign a comment. You can enter information
about the on-site cabling or the role of the device.
[Manufacturer] Shows the manufacturer name of the device. Some devices allow you to
input and edit the manufacturer name.
[Power consumption
(W)]
Enter the maximum power consumption of the device over a range of
0.0 – 90.0.
Enter the maximum power consumption of the connected device, when
known, to obtain an accurate view of the sum of the maximum power
that might be supplied to the connected device.
If [Power consumption (W)] is not entered, the maximum power supply
defined for the power supply class will be used to calculate the [Sum of
power might be supplied].
“IP address” Shows the IPv4 address of the device.
• button (opens the Web browser) : this opens the registered
URL in the Web browser.
This button is only displayed for connected devices whose IP
address can be acquired.
The destination URL is registered as the URL shown below by
default.
http://<IP_ADDR>/
Note: “<IP_ADDR>” is the IP address of a connected device
acquired by the Yamaha LAN Monitor
Press the button to open the registered URL in the Web
browser.
Press to display the context menu for the following items.
•
Access via Web browser
Opens the registered URL in the Web browser
•
Destination URL settings
Opens the destination URL settings dialog box.
In the destination URL settings dialog box, you can set the
[Destination URL] that is used when pressing the “Open in Web
browser” button.
“MAC address” Shows the MAC address of the device.
9. Map screen
36 | Yamaha LAN Monitor for Mac User Guide