User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding Yamaha PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave whose stack function is enabled
- Notes on printing and print preview of the "Whole map"
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Resources
Yamaha LAN Monitor User Guide
The following messages are shown in dialog boxes.
[mac] label: The power that might be supplied exceeds q W. The power being supplied from Yamaha switch might be
interrupted according to the condition.
[mac] label: Yamaha switch has detected down of portIp (portMac).
[mac] label: Yamaha switch has detected portIp (portMac).
[mac] label: Yamaha switch has stopped supplying power to portIp (portMac).
[mac] label: Yamaha switch has started supplying power to portIp (portMac).
[mac] label: Sum of power might be supplied has exceeded the maximum power supply capacity.
[mac] label: Port (n) of the Yamaha switch stopped supplying power because the maximum power has been exceeded.
[mac] label: Power being supplied from Yamaha switch has fallen below the guard-band (q W).
[mac] label: The power supply interruption on port (n) of the Yamaha switch was resolved.
[mac] label: Sum of power might be supplied has fallen below the maximum power supply capacity.
The snapshot file is invalid. Stopped loading snapshot file.
An invalid value was included in the information of the snapshot file. Only the valid information has been applied.
There are conflicting MAC addresses. The MAC address information that was listed first has been applied.
The label settings file is invalid. Stopped loading label settings file.
An invalid value was included in the information of the label settings file. Only the valid information has been applied.
Conflicting MAC addresses exist in the label settings file. The MAC address information that was listed first has been
applied.
The History file is invalid. Discarded History file.
This PC has no network interface.
There is no snapshot. Click the snapshot button to create a snapshot.
Dante Controller was not found. Please install Dante Controller.
The snapshot file could not be opened.
The snapshot file could not be saved.
The label setting file could not be opened.
Label setting file could not be saved.
Failed to update the firmware.
Failed to set the IP address.
Invalid IP address — the web settings screen could not be opened.