User Manual

Network settings on the computer

Yamaha LAN Monitor User Guide

Network settings on the computer

Configure network settings for your computer.

1. Connect the computer to a network device.

2. Start Yamaha LAN Monitor.

NOTE

If the “User Account Control” dialog box appears, click [Yes].

3. Click the [Setup] menu on the menu bar  [Open IP Settings for PC].

The “Network Connections” window appears.

4. Right-click the network adapter to which the network device is connected, and click

[Properties].

The “Ethernet Properties” dialog box appears.

5. Select [Internet Protocol Version 4 (TCP/IPv4)], and click [Properties].

The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box appears.

NOTE

If the [Internet Protocol Version 4 (TCP/IPv4)] check box is not selected, make sure to select it.

6. Set your IP address.

7. Click [OK].

8. Close the “Ethernet Properties” dialog box and the “Network Connections” window.

NOTE

In some cases, the Windows firewall might block Yamaha LAN Monitor. Select the [Private networks] check box, and click

[Allow access].

If the network is configured using DHCP

Select [Obtain an IP address automatically].

If a static IP address is set for each device

Select [Use the following IP address] and enter

an address.