User Manual

SWP1 Owner’s Manual
3
IMPORTANT NOTICE FOR THE UNITED KINGDOM
Connecting the Plug and Cord
WARNING: THIS APPARATUS MUST BE EARTHED IMPORTANT. The
wires in this mains lead are coloured in accordance with the following code:
GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this apparatus may not cor-
respond with the coloured markings identifying the terminals in your plug
proceed as follows:
The wire which is coloured GREEN-and-YELLOW must be connected to the
terminal in the plug which is marked by the letter E or by the safety earth
symbol or colored GREEN or GREEN-and-YELLOW.
The wire which is coloured BLUE must be connected to the terminal which
is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
(3 wires)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions con-
tained in this manual, meets FCC requirements. Modifica
tions not
expressly appr
oved by Yamaha may void your authority, granted
by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/
or another product use only high quality shielded cables. Cabl
e/s
supplied w
ith this product MUST be used. Follow all inst
allation
inst
ructions. Failure to follow instructions could void your
FCC
autho
rization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with
the requirements listed in FCC Regulations, Part 15 for Class “A”
digital devices. Compliance with these requirements provid
es a
r
easonable level of assurance that yo
ur use of this product, in a
commercial en
vironment, will not result in harmful interference
with other electronic devices. However, operation of this product in
a commercial area is likely to cause interference in so
me form. In
this case you, the user
, bear the responsibility of correcting
this
condition.
T
his product generates/uses radio frequencies and, if not inst
alled
and u
sed according to the instru
ctions found in the users manual,
may cause
interference harmful to the operation of other electronic
devices. Compliance with FCC regulations does not guarantee
that interference will not occur in all installations. If this product is
found to be the source of interference, which can be determined
by turning the product “OFF” and “ON”, please try to eliminate the
problem by using one of the following measures:
Relocate either the product generating the interference or the
device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the
antenna. If the antenna lead-in is 300 ohm ribbon lead, change the
lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results,
please contact the local retailer that is authorized to distribute this
type of product. If you can not locate the appropriate retailer,
please contact Yamaha Corporation of America, Electronic Ser-
vice Division, 6600 Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to those products distributed
by Yamaha Corporation of America or its subsidiaries.
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class A)
FCC INFORMATION (for US customers)