User Manual

SWP2 Owner’s Manual
15
Using commands to restore
factory settings
Factory settings can be restored using the [CONSOLE]
port or a Telnet or SSH client. The following describes
how to restore factory settings via the [CONSOLE] port.
Preparing the computer
Terminal software is required for controlling the computer
serial (COM) port. Before starting, configure the terminal
software parameter settings as indicated below.
1. Connect an RJ-45/DB-9 console cable
between the computer and SWP2 unit.
2. Turn on the power to the SWP2 unit.
A startup message is displayed on the computer
console screen.
3. Press the <Enter> key.
The software will wait for the user name to be
entered.
4. Enter the user name and press the <Enter>
key.
The software will wait for the password to be
entered.
5. Enter the password and press the <Enter>
key.
A command prompt will appear when the
password is successfully authenticated.
6. Enter “enable” and press the <Enter> key.
That will enable EXEC mode privileges.
7. Enter “cold start” and press the <Enter>
key.
The software will wait for the administrative
password to be entered.
8. Enter the administrative password and
press the <Enter> key.
The settings are restored to factory settings and
the SWP2 unit is restarted.
Pressing the <I> key during
startup to restore factory
settings
Factory settings can be restored by pressing the
uppercase <I> key during SWP2 startup.
Make sure the terminal software parameter settings are
already configured as indicated in “Using commands to
restore factory settings” above.
1. Connect an RJ-45/DB-9 console cable
between the computer and SWP2 unit.
2. Unplug the SWP2 power cord and plug it
back in.
That restarts the SWP2 unit.
NOTE
The following steps are the same even if the SWP2 unit
was restarted using command operations.
3. Within one second after “BootROM Ver.”
appears on the computer console screen,
press the uppercase <I> key.
The initialization confirmation screen is displayed.
4. Press the <y> key.
The settings are restored to factory settings and
the SWP2 unit is restarted.
Parameter Value
Data transmission speed 9600 bps
Character bit length 8
Parity check None
Number of stop bits 1
Flow control Xon/Xoff