User Manual

no lacp port-priority
[Parameter]
priority : <1-65535>
LACP port priority order
Lower numbers have higher priority
[Initial value]
lacp port-priority 32768
[Input mode]
interface mode
[Description]
Sets the LACP port priority order.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Note]
If up to eight LAN/SFP+ ports are combined into an LACP logical interface, they are immediately combined into the LACP
logical interface; ports in excess of eight are standby ports used in case of a malfunction.
In such cases, the priority order between the LAN/SFP+ ports are evaluated, and they are combined starting with the
highestpriority port.
The priority order is evaluated as follows.
1 ) Priority is given to ports with a lower LACP port priority.
2 ) If the LACP port priority is the same, priority is given to the lower interface number.
If an SFP+ port is to be given priority, its LACP port priority must be set lower than other ports.
[Example]
Set the LACP port priority order to 1024.
SWP2(config-if)#channel-group 1 mode active
SWP2(config-if)#lacp port-priority 1024
5.3 Port authentication
5.3.1 Configuring the IEEE 802.1X authentication function for the entire system
[Syntax]
aaa authentication dot1x
no aaa authentication dot1x
[Initial value]
no aaa authentication dot1x
[Input mode]
global configuration mode
[Description]
Enables IEEE 802.1X authentication for the entire system.
If this command is executed with the "no" syntax, disables IEEE 802.1X authentication for the entire system.
Use a RADIUS server for authentication on which the radius-server host command has been configured.
[Note]
In order to actually use IEEE 802.1X authentication, you need to enable IEEE 802.1X authentication on the applicable interface
as well.(dot1x port-control command)
[Example]
Enable IEEE 802.1X authentication for the entire system.
SWP2(config)#aaa authentication dot1x
Command Reference | Interface control | 137