User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Import/Export the CONFIG
Yamaha LAN Monitor for Mac User Guide
49
9. Check the execution results and output the results to a file if necessary.
NOTE
For the execution result of the CONFIG import, please refer to “Execution result of firmware/CONFIG bulk operation”
(page 61).
Export the CONFIG one by one
To export the CONFIG, follow the steps below.
1. Use one of the following methods to display the “Device Settings” dialog of the device that
supports CONFIG export.
• “Device Settings” button on the Map screen
• “Switch / Wireless AP List” tab on the List screen - “Setting” button