User Manual

[Power consumption
(W)]
Enter the maximum power consumption of the device over a range of 0.0 –
90.0.
Enter the maximum power consumption of the connected device, when
known, to obtain an accurate view of the sum of the maximum power that
might be supplied to the connected device.
If [Power consumption (W)] is not entered, the maximum power supply
defined for the power supply class will be used to calculate the [Sum of
power might be supplied].
“IP address” Shows the IPv4 address of the device.
• button (opens the Web browser) : this opens the registered URL
in the Web browser.
This button is only displayed for connected devices whose IP address
can be acquired.
The destination URL is registered as the URL shown below by default.
http://<IP_ADDR>/
Note: “<IP_ADDR>” is the IP address of a connected device acquired
by the Yamaha LAN Monitor
Press the button to open the registered URL in the Web browser.
Press to display the context menu for the following items.
•
Access via Web browser
Opens the registered URL in the Web browser
•
Destination URL settings
Opens the destination URL settings dialog box.
In the destination URL settings dialog box, you can set the
[Destination URL] that is used when pressing the “Open in Web
browser” button.
“MAC address” Shows the MAC address of the device.
[Keepalive] Select this check box to perform keepalive checks on the device. If this
check box is selected, Yamaha LAN Monitor pings the device to perform
keepalive checks according to settings configured in the “Basic Settings”
dialog box.
Selecting this check box will display the following depending on the
circumstances.
• Checking: Now checking.
• UP: Successfully detected device.
• DOWN: Failed to detect device.
[Power supply
interruption]
Restart devices directly connected to the PoE-enabled Yamaha switch by
turning the power supply on and off.
The duration of power supply interruption is set in the “Basic Settings”
dialog box by configuring the “Power supply interruption time”.
• [Auto] check box: Select this check box to temporarily turn off the
power supply to devices that could not be detected using [Keepalive].
This setting is only available when the [Keepalive] check box is
selected.
• [Execute] button: This manually interrupts the power supply. While
off, a “Stopped” message will appear.
9. Map screen
Yamaha LAN Monitor for Mac User Guide | 37