User Manual

For details, refer to the description provided for the Keepalive check box in the list (❷) for the
“Connected Devices” view.
Notes regarding an agent with the stack function enabled
Management of an agent, whose stack function has been enabled and the firmware revision is of the
following, is not supported.
Note that, even though detection is possible, correct information cannot be displayed.
• SWX3200-28GT/52GT Rev.4.00.15 or earlier
• SWX2310-28GT/52GT Rev.2.04.01 or earlier
• SWR2310-28GT Rev.2.04.01 or earlier
• SWX2310P-28GT Rev.2.02.14 or earlier
Notes on printing and print preview of the “Whole map”
Depending on the number of terminals displayed on the Whole map and the execution environment of
this software, the “Whole map” may not be printed or previewed correctly.
Such issues may be avoided by changing the “Preview size” of the “Whole map” to “A6.”
For details, refer to the description of the preview size of the “Whole map” described in the list
(❼) for the “Basic Settings” dialog box.
The maximum number of units that can be supported to print with this software is the number of
units that can be printed when the preview size is set to A6.
Notes regarding detection of Dante-enabled devices
If the network adapter selection has been changed after starting Yamaha LAN Monitor, Dante-
enabled devices may not be detected. If Dante-enabled devices cannot be detected, restart Yamaha
LAN Monitor.
Also, in the environment where Dante Controller has been installed, select the network adapter in
Dante Controller appropriately and then start Yamaha LAN Monitor.
Notes regarding when using macOS10.15.x or later
In macOS10.15.x or later, do not turn off Wi-Fi.
If Wi-Fi is off, Yamaha LAN Monitor cannot detect the network adapter.
1. Introduction
Yamaha LAN Monitor for Mac User Guide | 7