User Manual

[Initial value]
hostname SWP2
[Input mode]
global configuration mode
[Description]
Specifies the host name.
The host name specified by this command is used as the command prompt. If SNMP access is possible, this is used as the value
of the MIB variable sysName.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Example]
Set the host name as "yamaha."
SWP2(config)#hostname yamaha
yamaha(config)#
4.23.2 Reload system
[Syntax]
reload
[Input mode]
priviledged EXEC mode
[Description]
Reboots the system.
[Note]
If the currently-running settings (running configuration) have been changed from the settings at the time of boot (startup
configuration), reboot will discard those changes. Therefore, if necessary, you should execute the copy running-config
startup-config command or the write command before you execute the reload command.
[Example]
Reboot the system.
SWP2#reload
reboot system? (y/n): y
4.23.3 Initialize settings
[Syntax]
cold start
[Input mode]
priviledged EXEC mode
[Description]
Reboots with the factory settings. SYSLOG is also initialized.
[Note]
You must enter the administrator password when executing this command.
A special password can be inputted to initialize the settings only when logging in at the command prompt using a special
password.
[Example]
Initialize the settings.
SWP2#cold start
Password:
4.23.4 Set default LED mode
[Syntax]
led-mode default mode
no led-mode default
106 | Command Reference | Maintenance and operation functions