User Manual

[Parameter]
switch : Behavior EAP pass through
Setting value Description
enable Enable the EAP pass through
disable Disable the EAP pass through
[Initial value]
pass-through eap enable
[Input mode]
global configuration mode
[Description]
Enables/disables EAP pass-through, specifying whether EAPOL frames are forwarded.
If "disable" is specified, EAP frames are discarded.
If this is executed with the "no" syntax, or if "enable" is specified, EAPOL frames are forwarded.
[Note]
For interfaces on which 802.1X authentication is enabled, authentication functionality is given priority, and EAP pass-through
settings are not applied.
[Example]
Disable the EAP pass through.
SWP2(config)#pass-through eap disable
5.4 Port security
5.4.1 Set port security function
[Syntax]
port-security enable
port-security disable
no port-security
[Keyword]
enable : Enables port security function
disable : Disables port security function
[Initial value]
port-security disable
[Input mode]
interface mode
[Description]
Enables the port security function for the applicable interface.
If this is executed with the "no" syntax, or disable is specified, port security will be disabled for the applicable interface.
[Note]
This command can be specified only for both LAN/SFP+ port and logical interface.
Any unregistered terminals will be discarded at the time when the port security function is enabled.
[Example]
Enable port security for LAN port #1.
SWP2(config)#interface port1.1
SWP2(config-if)#port-security enable
148 | Command Reference | Interface control