User Manual

no ip forwarding [switch]
[Parameter]
switch : IPv4 packet forwarding settings
Setting value Description
enable Enable forwarding of IPv4 packets
disable Disable forwarding of IPv4 packets
[Initial value]
ip forwarding disable
[Input mode]
global configuration mode
[Description]
Enables or disables forwarding of IPv4 packets.
If this is executed with the "no" syntax, the setting returns to the default.
7.4.2 Show IPv4 forwarding settings
[Syntax]
show ip forwarding
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the IPv4 packet forwarding settings.
[Example]
Shows the IPv4 packet forwarding settings.
SWP2>show ip forwarding
IP forwarding is on
7.5 IPv4 ping
7.5.1 IPv4 ping
[Syntax]
ping host [repeat count] [
size datalen] [timeout timeout]
[Keyword]
repeat : Specifies the number of times to execute
size : Specifies the length of the ICMP payload (byte units)
timeout : Specifies the time to wait for a reply after transmitting the specified number of Echo requests
[Parameter]
host : Target to which ICMP Echo is sent
Host name, or target IP address (A.B.C.D)
count : Number of times to execute (if omitted: 5)
Setting value Description
<1-2147483647> Execute the specified number of times
continuous Execute repeatedly until Ctrl+C is entered
datalen : <36-18024>
Length of the ICMP payload (if omitted: 56)
Command Reference | Layer 3 functions | 195