User Manual

Authentication method Characters that can be inputted:
EAP-MD5, EAP-TTLS, PEAP, PAP
Single-byte alphanumeric characters and
symbols other than the characters \ [ ] " ? and
spaces
EAP-TLS
Single-byte alphanumeric characters and
symbols other than the characters \ [ ] / : * | < >
" ? and spaces
[Input mode]
priviledged EXEC mode
[Description]
Sends client certificates to each user via e-mail attachment.
Client certificates to be sent are ZIP files, compressed using the passwords for each user.
E-mail cannot be sent to users whose e-mail addresses have not been set.
To send e-mail, the e-mail destination server and e-mail recipient name must be configured in the e-mail template, and an e-
mail template ID for use when sending the e-mail must be set using the mail send certificate command.
[Note]
Only the newest client certificate (1) can be sent via e-mail.
[Example]
This sends a client certificate via e-mail to the user with the “Yamaha” user ID.
SWP2#certificate export mail user Yamaha
10.1.14 Show RADIUS client (NAS) status
[Syntax]
show radius-server local nas host
[Parameter]
host : IP address or IP network address
Setting value Description
IPv4 address (A.B.C.D)
Range from 0.0.0.1 to 223.255.255.255, except
for 127.0.0.1
IPv4 network address (A.B.C.D/M)
The network mask range is from 8 to 32, and the
IP address host part will be “0”
IPv6 address (A:B:C::D)
Out of all unicast addresses, the exceptions are
unspecified addresses (::/128), default root
addresses (::/0) and loopback addresses (::1/128)
IPv6 network address (A:B:C::D/M) The prefix length is 1–128
[Input mode]
priviledged EXEC mode
[Description]
Shows a list of RADIUS clients (NAS).
[Example]
Shows the RADIUS clients (NAS) with an IP address of “192.168.100.0/24”.
SWP2#show radius-server local nas 192.168.100.0/24
host key
-------------------------------------------------------------------------------------
-------------------
192.168.100.0/24 abcde
274 | Command Reference |
Application