User Manual
• Settings related to firmware updating
• Settings related to SYSLOG
•
Settings related to HTTP server functions
• Settings related to Telnet server functions
• Settings related to SSH server functions
• Settings related to TFTP server functions
Saves the settings of certain functions to the backup configuration.
If a backup configuration exists when the SWP2 starts in DANTE mode, those settings are restored to the running
configuration.
[Note]
This command can be used only when the configuration mode of the SWP2 is DANTE mode.
[Example]
Save the settings of the applicable functions to the backup configuration.
SWP2#backup-config
Succeeded to write backup configuration
SWP2#
4.3.4 Show the running configuration
[Syntax]
show running-config [section]
[Parameter]
section : Section to be shown
Setting value Description
access-list Access list related
http-server HTTP server related
interface Interface related
ip IP related
ipv6 IPv6 related
key Authentication key related
l2ms L2MS related
lldp LLDP related
mail E-mail notification-related
radius-server RADIUS server related
snmp SNMP related
spanning-tree STP related
ssh-server SSH server related
telnet-sever TELNET server related
[Input mode]
priviledged EXEC mode, individual configuration mode
[Description]
Shows the currently-operating settings (running configuration).
If section is not specified, all settings are shown.
[Example]
Show the running configuration.
SWP2#show running-config
!
Command Reference | Maintenance and operation functions | 35