User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Toolbar and display area
Yamaha LAN Monitor for Mac User Guide
19
1 Ping
You can ping one or more specified IP addresses. Select a radio button to specify which type of test you
want to execute.
Click the [Execute] button to start a ping test. The results of the ping test appear in the Result of searching area.
When you select [IP address] and execute a ping test, the Result of searching area displays the test results
regardless of whether there is a reply.
When you select [IP address range] and execute a ping test, the Result of searching area lists only the IP
addresses that replied.
• [IP address]:
Select this to ping a single IP address.
• [IP address range]:
Select this to ping a specified range of IP addresses.
From: Enter the starting IP address.
To: Enter the ending IP address.
• [Number of target IP address:]:
Shows the number of IP addresses in the specified range.
During a ping test, this shows the number of sent ping messages and the rate of progression.
• [Execute]/[Stop] button:
Click the [Execute] button to start a ping test.
During the ping test, this button switches to [Stop]. You can click this button to terminate the ping test.
2 Auto search in local network
This area shows the network information and the number of target IP addresses of the network to which the
selected network adapter belongs. Click the [Execute] button to start a search. The results of the search
appear in the Result of searching area.
The Result of searching area lists only IP addresses that replied.
• [Local network:]:
Shows the network information of the network to which the network adapter belongs.
• [Number of target IP address:]:
Shows the number of IP addresses to be searched. During a search, this shows the number of searched
IP addresses and the rate of progression.
• [Execute]/[Stop] button:
Click the [Execute] button to start a search.
During the search, this button switches to [Stop]. You can click this button to terminate the search.
3 Result of searching area
Shows the results of a ping test or an auto search in local network (page 41).
Important
Do not change the IP address and subnet mask of the selected network adapter during a search.
1
2
3