User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Map screen
Yamaha LAN Monitor for Mac User Guide
27
Tree view
This area shows the Yamaha switch, and Dante-enabled devices detected by Yamaha LAN Monitor. The device
name and the number of connected devices (slave devices only) are shown at the right of the icon; when you click
the open/close button [>] located at the left of the icon, the devices connected below that slave device are shown.
NOTE
This will not function until a Yamaha switch is found.
1 Sorting order reference node selection pull-down menu
Selects the Yamaha switch that you want to appear at the top of the tree view. These are shown in their
connection order relative to the selected Yamaha switch.
NOTE
• Only the Yamaha switch for the current network will appear in the sorting order reference node selection pull-down menu.
• When starting Yamaha LAN Monitor, the Yamaha switch closest to the computer will serve as the starting point for the tree
view.
2 Tree view
This area shows the Yamaha switch, and Dante-enabled devices detected by Yamaha LAN Monitor.
If a device that was saved in the snapshot is no longer found, or if the connection port is different, a red error
icon ( ) is shown for the slave that is above the corresponding device. If a device that was not saved
previously is newly found, a blue notification icon ( ) appears on the slave that is above the corresponding
device.
“Connected Devices” view
When you click a Yamaha switch shown in the tree view, a list of the connected devices is shown in the “Connected
Devices” view.
The “Connected Devices” view is updated each time that the time specified in “Information update interval of the
selected slave” - “Status of each function” of “Basic Settings” has elapsed (
page 14
).
When you click the [Refresh] button of the “Connected Devices” view, information for the devices connected to the
slave is refreshed.
1
2
1
2
3