User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Update the firmware
Yamaha LAN Monitor for Mac User Guide
42
5. Wait until the progress bar reaches 100%.
6. After the reboot of the device with updated firmware is complete, check the firmware revision
of the updated device.
Update firmware on multiple units at once
To update the firmware on multiple units all at once, follow the steps below.
NOTE
Firmware update is executed in order of the devices farthest away from the LAN Monitor, so the firmware can be updated in
batches while maintaining the cascade connection.
1. Press the “List” button to open the List screen.
2. Press the “Firmware Update” tab.
3. Check the checkboxes of the devices for which you want to update the firmware.
LAN Monitor
Device A
Send 1st
Device B
Send 2nd