User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Toolbar and display area
Yamaha LAN Monitor for Win User Guide
20
[Notifications] button / “Notification area”
Shows a message in the “Notification” area when there is a change in the current network and snapshot (the
previously-saved network status). The message disappears when the network returns to the same state as the
snapshot.
NOTE
• The message history is added to the History area. Click the [ ] button to display the History area.
• For details on the types of messages displayed, refer to “Messages shown in both the Notification area and the History area”
(page 57).
If a change is detected
A message (page 57) appears in the “Notification” area. If a device that was saved in the snapshot is no longer
found, or if the connection port is different, a red error icon ( ) is shown for the slave that is above the
corresponding device. If a device that was not saved is newly found, a blue notification icon ( ) appears on
the slave that is above the corresponding device.
1 “Notification area”
Messages regarding the current network are shown here. When a new message is added, the Notification
area appears automatically. The Notification area can also be displayed by clicking the [ ] button.
When a message is displayed, you can close the Notification area by clicking the [ ] button.
Date/Time: Shows the date and time at which the message was output.
Messages: Shows the message that was output by the switch function or snapshot function.
1
2 3