User Manual
Table Of Contents
- Yamaha LAN Monitor for Mac
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Mac
13. Import/Export the CONFIG
LAN Monitor allows you to import/export CONFIG in the following two ways.
• Importing/exporting from the “Device Settings” dialog, one unit at a time
• Importing/exporting from multiple units at once from the “Config Import/Export” tab on the
List screen
NOTE
• By using the CONFIG export function, you can back up the CONFIG file of the
agent device to your PC.
• You can use the CONFIG import function to apply CONFIG data to an agent
device, including CONFIG data that was prepared in advance or data backed up
from an agent device.
• Since L2MS is used for CONFIG import/export, it is easy to import/export the
CONFIG even without an IP address configured.
13.1. Import the CONFIG one by one
To import the CONFIG, follow the steps below.
1. Use one of the following methods to display the “Device Settings” dialog of the device that
supports CONFIG import.
◦ “Device Settings” button on the Map screen
◦ “L2MS Agent List” tab on the List screen - “Setting” button
13. Import/Export the CONFIG
56 | Yamaha LAN Monitor for Mac User Guide