User Manual

Please change the default password for admin.
New Password:
New Password(Confirm):
Saving ...
Succeeded to write configuration
If the incorrect password is entered three times in a row, you will be restricted from logging in for one minute. After one minute
has passed, please enter the correct password.
• Login restriction screen
Username: user
Password:
% Incorrect username or password, or login as user is restricted.
Password:
% Incorrect username or password, or login as user is restricted.
Password:
% Incorrect username or password, or blocked upon 3 failed login attempts for user.
% Please try again later.
• If a restricted user enters the wrong password again, the time limit will be refreshed.
• After the restriction time limit expires, you can log in by entering the correct password.
2.4 Command input mode
2.4.1 Command input mode basics
In order to change the settings of the SWP2 or to reference the status, you must move to the appropriate command input mode
and then execute the command. Command input mode is divided into hierarchical levels as shown below, and the commands
that can be entered in each mode are different. By noting the prompt, the user can see which mode they are currently in.
The basic commands related to moving between command input modes are described below. For commands that move from
global configuration mode mode to individual configuration mode, refer to "individual configuration mode."
• exit command
• logout command
• enable command / administratorcommand
• disable command
• configure terminal command
• end command
18 | Command Reference | How to use the commands