User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Menu bar
Yamaha LAN Monitor for Win User Guide
14
5 Power supply interruption time
Suspends the power supply when a disrupted or inactive connection is detected. Set the power supply
interruption time in seconds in case of interruption.
Setting range: 1 – 60 sec
Default: 5 sec
6 Preview size of the Whole map
Select the size of the preview image of the “Whole map” generated for print preview and printing.
If printing or previewing the “Whole map” has failed, the failure may be avoided by setting the preview size to A6.
7 Snapshot function
• “Treat equipment as comparison for snapshots” check box:
Clear this check box to exclude devices as targets for comparisons.
Default: Selected
8 [OK] button
Applies the configured settings.
NOTE
• The [OK] button is only available when acceptable input values have been input.
• Click the [OK] button to reset the monitoring timer and begin counting from 0 seconds again.
9 [Cancel] button
Closes the dialog box without applying setting changes.
[VLAN registration]
Open the “VLAN registration” dialog box.
Register the VLAN to use with the Yamaha LAN Monitor.
The VLAN you register here will be used when configuring the tagged VLAN for the switch.
Also, as the registered VLAN information is recorded in the label settings file, you can export the file from the
“Export Label Settings” in the Setup menu.
1 List of registered VLAN
Displays the list of the VLAN registered with the Yamaha LAN Monitor.
“VLAN ID:1” is registered as the default VLAN and cannot be changed.
2 “Register number” input area
Input the VLAN registration number here.
This number is used when configuring a tagged VLAN only on the SWX2200 series.
If you are not using the SWX2200 series, this number is only used as the ID number on the Yamaha LAN
Monitor, and has no relation to the switch’s VLAN settings.
From two to 255 single-byte characters can be used for this value.
You cannot set the same number twice.
1
2
❼❽
5
3
4 ❻