User Manual

8. Toolbar and display area
This section describes the display area and each button on the toolbar: [Device search], [Snapshots],
[Notifications], [History], [Whole map] and [Dante Controller].
❶ Network adapter selection pull-down menu
❷ [IP Address (PC)]
❸ Screen switching button
❹ [Device search] button
❺ [Snapshots] button
❻ [Notifications] button
❼ [History] button
❽ [Whole map] button
❾ [Dante Controller] button
8.1. Network adapter selection pull-down menu
Select the network adapter to be monitored by Yamaha LAN Monitor from the pull-down menu.
If you change the network adapter, the snapshot internally held in Yamaha LAN Monitor is discarded.

NOTE
Network adapters that have been disabled on a PC running Yamaha LAN Monitor will
not appear.
When Yamaha LAN Monitor is started, the network adapter specified as the Dante
shared interface is selected.
If the Dante Discovery/Dante Control and Monitoring function or Dante Controller is
not installed, the network adapter that was selected when you last exited will be
used.
If you change the network adapter selection, Dante-enabled devices may not be
detected, but restarting Yamaha LAN Monitor will allow them to be detected
normally.
8.2. [IP Address (PC)]
Indicates the IP address that is assigned to the currently selected network adapter.
8. Toolbar and display area
24 | Yamaha LAN Monitor for Win User Guide