User Manual
Table Of Contents
- Yamaha LAN Monitor for Win
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Win
14.2. Messages shown in both the Notification area and the
History area
Messages shown in both the “Notification” area and the “History” area are as follows.
14.2.1. Switch function error messages
The following messages appear when an error occurs with the switch function. mac indicates the MAC
address of the device that is the subject of the message, label indicates the label identifying the
device (does not appear when left blank), m indicates the stack ID, n indicates the port number, t
indicates the temperature, x indicates the QoS transmit queue number, and fn indicates the fan
number. “(Stack ID: m)” is not displayed for switch devices that do not have the stack function
enabled.
Messages
[mac] label: The fan of the Yamaha switch malfunctioned.
[mac] label: A loop occurred at ports (n1, n2…) of the Yamaha switch.
[mac] label: Port (n) of the Yamaha switch stopped supplying power.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class0 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class1 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class2 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class3 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class4 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class5 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class6 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class7 device.
[mac] label: Port (n) of the Yamaha switch started supplying power to a Class8 device.
[mac] label: Port (n) of the Yamaha switch stopped supplying power because a class of device which
exceeded the power supply class setting was detected.
[mac] label: Class3 (15.4W) power from port (n) has stopped because paired port began supplying
Class4 (30W) power.
[mac] label: The power supply has stopped because the maximum power has been exceeded at port (n).
[mac] label: Port (n) of the Yamaha switch stopped supplying power because the maximum power has
been exceeded.
[mac] label: Port (n) of the Yamaha switch stopped supplying power because the internal temperature
exceeded t degrees Celsius.
[mac] label: Port (n) of the Yamaha switch stopped supplying power because the fan malfunctioned.
[mac] label: Port (n) of the Yamaha switch stopped supplying power because the power supply
malfunctioned.
[mac] label: The Yamaha switch has stopped supplying power.
[mac] label: An error occurred in the power supply of the Yamaha switch.
[mac] label: The power being supplied from the Yamaha switch has exceeded the maximum power
supply capacity.
[mac] label: Connected via the backup route. (Main route: port (n))
14. Resources
70 | Yamaha LAN Monitor for Win User Guide