User Manual
Table Of Contents
- Yamaha LAN Monitor for Win
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Win
2.3. Installing Dante Controller
Dante Controller must also be installed to launch Dante Controller from Yamaha LAN Monitor. For
details on installing Dante Controller, refer to the “Dante Controller User Guide.”
You can download Dante Controller and the Dante Controller User Guide from the downloads page of
the website below.
https://www.audinate.com/products/software/dante-controller
NOTE
Yamaha LAN Monitor uses the same network adapter as the one selected in Dante
Controller to detect Dante-enabled devices. Therefore, in the environment where
Dante Controller is installed, select the network adapter in Dante Controller
appropriately and then start Yamaha LAN Monitor.
When selecting a network adapter with Dante Controller, it is necessary to check
“Use Shared Dante Interface”. If you change the network adapter selection in Yamaha
LAN Monitor, the network adapter selection status of other applications (such as
Dante Controller) that use the Dante shared interface will also be changed.
2. Installing and uninstalling Yamaha LAN Monitor
Yamaha LAN Monitor for Win User Guide | 9