User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Toolbar and display area
Yamaha LAN Monitor for Win User Guide
18
[Device search] button
Opens the “Device search” dialog box. This function can use specified IP addresses to ping devices that are
connected to the current network. This function also can search the IP addresses of all devices that are connected
to the current network.
If the “Connected Devices” view does not list some devices on which you want to perform keepalive checks (life/
death monitoring), you can execute this function to list the devices in the “Connected Devices” view.
NOTE
A device that was discovered by the Device search function will disappear from the “Connected Devices” view if the device
does not communicate for a certain period of time. If you want a discovered device to appear continuously in the “Connected
Devices” view, enable keepalive check on the device. For details on keepalive check, refer to the description provided for the
Keepalive check box in 2 List for the “Connected Devices” view (page 26).
1 Ping
You can ping one or more specified IP addresses. Select a radio button to specify which type of test you
want to execute.
Click the [Execute] button to start a ping test. The results of the ping test appear in the Result of searching area.
When you select [IP address] and execute a ping test, the Result of searching area displays the test results
regardless of whether there is a reply.
When you select [IP address range] and execute a ping test, the Result of searching area lists only the IP
addresses that replied.
• [IP address]
Select this to ping a single IP address.
• [IP address range]
Select this to ping a specified range of IP addresses.
From: Enter the starting IP address.
To: Enter the ending IP address.
• [Number of target IP address:]
Shows the number of IP addresses in the specified range.
During a ping test, this shows the number of sent ping messages and the rate of progression.
• [Execute]/[Stop] button
Click the [Execute] button to start a ping test.
During the ping test, this button switches to [Stop]. You can click this button to terminate the ping test.
1
2
3