User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Map screen
Yamaha LAN Monitor for Win User Guide
28
NOTE
• If multiple Dante-enabled devices are connected in a daisy-chain, the other devices are also shown together at the same
port number as the device that is connected immediately below the switch.
• Of the settings in the above list, the settings of “Device Type”, [Device Label], [Model name], [Manufacturer], [Keepalive],
[Power supply interruption] and [Destination URL].
Note that the “Label Settings file” generated by this software version cannot be imported to the software version 1.3.6 or
earlier.
• can be moved to another computer by using the [Setup] menu commands [Export Label Settings] and [Import Label
Settings].
• Note that a snapshot notification will not be provided even if the keepalive status changes from “UP” to “DOWN.”
List entry
To enter information in a list, or edit entered information, double click a cell.
Entries up to the following character counts and within the following ranges are permitted.
• [Device Label], [Model name], [Comment], [Manufacturer]: Up to 128 characters
• [Power consumption (W)]: Up to the first decimal place within a range of 0.0 – 90.0
NOTE
Content entered into the [Device Label] and [Comment] fields are shared with “Device Settings” dialog box (page 25).
Changing entries in one will change the corresponding entry for the other.
Show connection status
A snapshot saves the connected state of the devices at the time that you started monitoring.
Subsequently, if a device saved in the snapshot is no longer found, the corresponding device is shown in red. If
a device that had not been saved previously is newly found, the corresponding device is shown in blue.
3 [Refresh] button
Refreshes the information for the other slaves or devices that are connected to the slave selected in the tree
view.
[Keepalive]
Select this check box to perform keepalive checks on the device. If this check box is selected,
Yamaha LAN Monitor pings the device to perform keepalive checks according to settings
configured in the “Basic Settings” dialog box (page 13).
Selecting this check box will display the following depending on the circumstances.
• Checking: Now checking.
• UP: Successfully detected device.
• DOWN: Failed to detect device.
[Power supply
interruption]
Restart devices directly connected to the PoE-enabled Yamaha switch by turning the power
supply on and off.
The duration of power supply interruption is set in the “Basic Settings” dialog box by configuring
the “Power supply interruption time” (page 14).
• [Auto] check box: Select this check box to temporarily turn off the power supply to devices
that could not be detected using [Keepalive]. This setting is only available when the
[Keepalive] check box is selected.
• [Execute] button: This manually interrupts the power supply. While off, a “Stopped” message
will appear.